XADO Tuning Atomic Metal Conditioner is an engine treatment that rebuilds metal. One bottle of Tuning Atomic Metal Conditioner contains enough Revitalizant for 33% (RF33) of a complete cycle of revitalization for an automobile engine. The difference between this product and 1 Stage Maximum Atomic Metal Conditioner is this product contains 1/3 of the raw, active ingredient – Revitalizant - that Maximum contains. Tuning was created for high-compression or modified automobiles that may not require a complete 100RF revitalization cycle at once. This product can also be used in normal automobiles as some prefer to Revitalize their engines slowly by using three (3) bottles of Tuning Atomic Metal Conditioner instead of one 225ml bottle of 1 Stage Maximum Atomic Metal Conditioner. This treatment works in gasoline-powered, diesel-powered, and natural-gas powered engines.
No matter how well a car is maintained, high heat and friction cause a car’s engine to become worn, scratched, and misshapen over time. Adding XADO Tuning Atomic Metal Conditioner to your engine oil rebuilds worn engine metal and coats the rebuilt metal at the friction points with a self-regulating layer of ceramic-metal to prevent future wear. Unlike other engine treatments that must be added during every oil change, a complete cycle of revitalization with XADO Tuning Atomic Metal Conditioner will protect for 62,000 miles.
XADO’s innovative patented nano-technology is the result of 20 years of research and development. When added to an automobile’s engine oil, Revitalizant rebuilds engine metal at the atomic level, reversing wear, restoring engine geometry, and adding a self-regulating layer of ceramic-metal protection to prevent future wear. XADO Revitalizant does not cake, flake, or alter oil viscosity. This makes it safe to use in even the most sensitive vehicles. XADO’s Revitalizant technology has been independently tested and proven to work.
Revitalizant is unlike any other engine treatment, because it actually works to rebuild metal, targeting the source of engine wear instead of merely masking the symptoms. Revitalizant – the active ingredient that rebuilds metal – is activated by high-heat and friction, so it only repairs metal at high friction points where metal wear occurs. Revitalizant leaves crank-cases and non-friction metal unaffected.
XADO Tuning Atomic Metal Conditioner has a Revitalization factor of 33.3 (RF33.3) for 33% of the Active ingredient necessary for 1 complete revitalization cycle for an automobile engine of up to 5quarts of oil capacity. Three (3) bottles of Tuning Atomic Metal Conditioner= 100% (RF100)
- Compensates current wear of engine
- Can double or triple the life of an engine
- Increases engine compression
- Restores lost oil pressure
- Protects metal parts from overheating and overloading
- Improves lubricating properties of oil and tribological characteristics of engine units
- Decreases noise and vibration level
- Reduces fuel consumption
- Increases power and acceleration capability
Technology and certificates
Make sure automobile engine is warmed up to normal operating temperature. Turn off vehicle. Shake bottle for one minute and ensure bottle is at room temperature so that contents flow freely. Pour contents into engine oil reservoir. Start car and let engine idle for five minutes. Then drive as you normally would. It takes 600 to 900 miles to complete the Revitalization cycle, during which changing oil is NOT recommended.
*Granules with atomic Revitalizant completely dissolve in motor oil at normal operating temperature.
*1 bottle treats an automobile engine with an oil capacity of up to 10 quarts of oil. Three applications of Tuning are necessary to complete the revitalization cycle.
Keep out of reach of children. Avoid contact with skin and eyes. If swallowed, seek medical attention immediately and show this container or label to medical personnel. Avoid release into the environment; refer to special instructions/ material safety data sheet.
Material safety data sheet is available for professional user on request.
- XADO Tuning Atomic Metal Conditioner works in gasoline-powered, diesel, and natural-gas powered engines of passenger cars and small trucks and 4-stroke motorcycles with oil system up to 5 Quarts
- Can be combined with all types of motor oils, from full synthetic to mineral oils
- It takes 600 to 900 miles to complete the Revitalization cycle, during which changing oil is NOT recommended
- For the turbocharged and high forced engines, application during each oil change is recommended
- For a complete revitalization cycle it is recommended to use XADO Maximum 1 Stage (RF 100)
- For the highest level of protection for your automobile engine use XADO Atomic Oil or XADO HighWay Metal Conditioner (RF5.5) during each oil change. XADO Highway contains 5.5% (RF5.5) of the active ingredient necessary for 1 complete revitalization cycle. A complete oil change using XADO Atomic Oil also provides 5.5% (RF5.5) of the revitalization necessary for a complete Revitalization cycle
Your opinion is important to us:
«Atomic Metal Conditioner Tuning with Revitalizant»: